Troubleshooting - AEG Electrolux CREMAPRESSO Anleitung

Troubleshooting

A) Both indicator lights for 1 and 2
en
cups are flashing:
• The water tank is empty.
B) All indicator lights are flashing:
• If steam/hot water has been used for
too long, make a pause for 30 seconds.
• Switch the machine off for 5 minutes
and restart it. If the lights are still flash-
ing, contact customer support.
C) The espresso temperature is too low:
• Carry out the brewing procedure with-
out using espresso grounds, but using
the filter and filter holder, in order to
preheat the system.
• Preheat the cups.
• Decalcify the appliance.
D) The flow speed decreases notice-
ably:
• Do not press the espresso grounds too
firmly into the filter.
• Do not grind the espresso grounds too
finely ("medium" fineness).
• Decalcify the appliance.
ELX12542_Franca_Espresso_Button_AEG_3lang.indd 13
E) The espresso is flowing out of the
side of the filter holder:
• Ensure that the filter holder has been
placed correctly.
• Twist the filter holder a little more
firmly into the retainer.
• Clean any espresso grounds away
from the rim of the filter holder.
F) No espresso is coming out:
• If there is a loud noise from the ma-
chine, this means air is in the system.
Let hot water flow through the nozzle
until there is a steady flow. Then try
brewing coffee again.
• Ensure that the water tank has been
filled and is correctly in place.
• Ensure that the filter holder has been
placed correctly.
• Ensure that the selector dial has been
turned right to the position.
• Do not press the espresso grounds too
firmly into the filter.
• Clean the brew filter.
• Decalcify the appliance.
G) The crema is no longer being pro-
duced as it should:
• Ensure that there are enough espresso
grounds in the filter.
• Press the espresso grounds lightly.
• Clean the filter.
H) Too little milk froth is created when
steaming milk:
• Always use cool, fresh, low-fat milk.
• Clean the steam nozzle.
I) The flow increases:
• The espresso grounds have been
ground too rough.
• Ensure that there are enough espresso
grounds in the filter.
J) The coffee machine switches itself
off while operating:
• The appliance pump is equipped with
a temperature fuse that protects it
from overheating. The temperature
fuse interrupts the machine's opera-
tion, if the machine is operated for
too long or if the pump is run without
water.
• Set the selector dial to "0" and remove
the plug from the mains socket.
• Leave the machine to cool for at least
20 minutes. Fill up with water.
• Plug the appliance into the mains
again and switch it on. If the appliance
still does not work, please contact our
Customer Care Department.
2009-06-10 10:29:59
de
GR
en
13