Cleaning The Cooking Compartment; Removing And Fitting The Appliance Door - CONSTRUCTA CF210250 Gebrauchsanleitung

Appliance part/ Cleaning agent/aid
surface
Painted surfaces/ Apply washing-up liquid with a soft,
glass surfaces damp cloth or chamois; dry with a soft
cloth.
Door panels Apply glass cleaner or detergent with a
soft, damp cloth or chamois leather; dry
with a soft cloth.
The inner door panel on the appliance
door has a coating which can have the
effect of a light-coloured film.

Cleaning the cooking compartment

Caution!
Risk of damaging the surface. Do not clean the appliance while
still warm, even if using oven cleaners specially intended for
this purpose.
Notes
Due to its technical properties, the enamel can exhibit colour
■
variations, this however has no effect on the function.
The edges of thin trays may be rough. Anti-corrosion
■
protection is still guaranteed, however.
Appliance part Cleaning agent/aid
Enamel Apply washing-up liquid or vinegar solution
surfaces with a soft, damp cloth or chamois; dry with a
soft cloth. Loosen baked-on food residues
with a damp cloth and detergent. Leave the
cooking compartment open to dry after
cleaning.
We recommend using oven cleaning gel if the
oven is very dirty. This can be applied directly
to the stain.
Door seal Hot soapy water
Hook-in rack Hot soapy water
Accessories Soak in hot soapy water. Clean with a brush
and sponge or wash in the dishwasher.
Keeping the appliance clean
Clean the cooking compartment after each use, as dirt will
bake on the next time it is heated up, and this can only be
removed with difficulty. Always remove flecks of limescale,
grease, starch and albumin (e.g. egg white) immediately.

Removing and fitting the appliance door

You can remove the appliance door to clean it more
thoroughly.
m
Risk of injury!
The hinges of the appliance door may snap shut with great
force. Always open the hinge locking lever fully when removing
the appliance door and close it fully after refitting. Do not reach
into the hinge.
m
Risk of injury!
If the appliance door has only been unhinged on one side, do
not reach into the hinge. The hinge can snap back with great
force. Call the after­sales service.
Removing the appliance door
Open the appliance door fully.
1.
Open the locking levers on the left and right-hand side fully.
2.
42
The hinges are secured and cannot snap closed.
Close the appliance door until resistance becomes
3.
noticeable (figure A).
With both hands, grip the door on the left and right-hand side,
4.
close the door a little more and pull it out (figure B).
A
Fitting the appliance door
Insert the hinges in the left and right-hand holders (figure C).
1.
The notch on both hinges must engage.
Open the appliance door fully.
2.
Close the locking levers on the left and right-hand side fully
3.
(figure D).
C
The appliance door is secured and can no longer be
removed.
Close the appliance door.
4.
Cleaning the door panels
To assist with cleaning, the inner door panel can be removed
from the appliance door.
m
Risk of injury!
The components inside the appliance door may have sharp
edges. Take care not to cut yourself. Wear protective gloves.
m
Risk of injury!
The appliance must not be used again until the door panels
and appliance door have been correctly fitted.
Removing the door panel
Note: Before removing, make a note of the orientation in which
the door panel is fitted, so that it is not refitted the wrong way
round.
B
D