Instructions To Remove / Replace Inside Glass Panels; Folding The Heating Element Down/Away; Shelf Runner Assembly And Disassembly; Regeneration Of The Ökotherm® Catalyst - Küppersbusch EEB9860.0 Gebrauchsanleitung

Attaching the oven door.
– Hold the oven door with both hands and insert the hinges in the corres-
ponding slots. The hinge should fi t snugly.
– Slowly open the door fully.
– Again lower the supports on the door
hinges.
– Close the oven door.
Instructions to remove / replace inside glass
panels
1 Open the oven door.
2 Fully rotate the two clamps (D) to stop
the door from closing.
3 Squeeze point 1 located on the upper
part of both sides of the oven door.
4 Continue squeezing point 1 and pull
out the upper clasp of the door.
5 The inside glass panels will now be loose and can be easily cleaned with
window cleaning liquid and a soft cloth.
Warning
If the door has not been blocked with the clamp (D), please take care
when removing the inside glass panels as the oven door will close.
6 Once clean, return the glass panels in the same order so that the word
TERMOGLASS can be read.
7 Replace the upper clasp of the door, making sure that the side tabs fi t in
point 1.
EEB 9860.0

Folding the heating element down/away

• Using both hands, push the grill
element (A) until releasing it from the
two upper rods.
• Rotate the element and clean the top
of the oven.
• Finally, place the grill element back in
its original position.

Shelf runner assembly and disassembly

1 Remove accessories from the inside of the oven.
2 Pull out the supports or the telesco-
pic guides (B), releasing them from
the nut (C).
D
3 To refi t the supports, enter the ends of the supports into the lower holes
on the sides of the inside of the oven (D) and tighten with the nut.
Assembling the shelf runners
– Position the shelf runners and attach the nuts.
Regeneration of the ökotherm®
catalyst
The ökotherm® catalyst dissolves the grease particles and smells
produced when roasting with the Hot Air cooking setting. This process is
suffi cient with the normal use of the Hot Air setting. In special cases
(well-cooked roasts in large quantities) it is possible that small grease
particles will be deposited on the catalyst. When you use the oven again
e.g. when cooking a pizza, they will be gradually dissolved.
If you believe that the catalyst is not cleaning as well as it should
(it smells a lot) you can regenerate it by eliminating the remains of
accumulated grease.
Regeneration of the ökotherm® catalyst
– Select the Hot Air service function.
– Set the thermostat to 200° C and
– heat the empty oven for 60 mins.
A
B
C
D
D
47