teutonia Mistral S Bedienungsanleitung Seite 13

Adjusting the Backrest
Adjusting the footrest
Using the Five-Point Harness
Open the harness by pressing both sides of the buckle
latches as shown in Figure 1. It is not necessary to sep-
arate the chest restraints from the crotch restraints. Sit
your child in the stroller, move both its arms through the
harness opening and insert the buckle latch into the
crotch belt latch. Using the adjusters, adjust the harness
as shown in Figure 2.
Warning: Always use the crotch strap in combination with
the waist belt. Attaching points (D-ring) for a separate
belt harness are provided at the outer ends of the
crotch restraint.
Using the Reclined Surface Extension
(available as an accessory)
If you need to, you can attach the washable bed exten-
sions at the foot of the sports buggy inlay using the push
locks.
Pull the grip 1 upwards and
move the backrest 2 into the
required position. Please
make sure that the backrest
re-engages properly.
Raise the footrest and allow
the bar to click into place at
the marked notch. When
releasing it, hold the bar in
the centre of the latching
notch and raise the footrest.
Safety bar
Push the insert pieces on the safety bar through the
slots in the seat cover into the receptacles beneath,
which are located in the armrests. Make sure that the sa-
fety bar has clicked into place on both sides. To remove
it, press the release buttons on the insert pieces. In or-
der to make it easier for your child to get in and out, it
suffices to release and fold up one side of the bar.
Special features of the model variations
screw on the brake lever.
Note: The brake should only be used to slow the wheels,
not to block them.
Warning: When reordering rear wheels, please ensure
that the supplier is aware of the deceleration brake as
the brake requires a special brake disc. The foot brake
will not function if the wrong brake disc is used!
MISTRAL S
Models with deceleration
brake:
You are able to control the de-
celeration brake using the
brake on the handlebar. The
braking action can be fine-
tuned using the adjustment
INT
13