Initial Use; Fitting/Changing The Saw Blade; Fitting The Protective Cover; Fitting The Guide Fence - Parkside PSTDA 18-Li A1 Betriebsanleitung

Initial use

Fitting/changing the saw blade

Remove the battery before carrying out any
work on the power tool (e.g. maintenance, tool-
changing, etc.) as well as during carriage and
storage of the power tool.
Unintentional depressing of the On/Off button can
result in injury.
♦ Push the protective cover
outer holders and pull it off toward the front.
♦ Turn the quick-release chuck
this position.
♦ Press the required saw blade into the quick-
release chuck as far as the limit stop.
♦ Release the quick-release chuck
its initial position. The saw blade is now locked.

Fitting the protective cover

Mount the protective cover
the machine to the dust extraction.
♦ Mount the protective cover
in such a manner that the two outer holders
engage in the openings on the casing.
♦ Remove the protective cover
without dust extraction as well as when perform-
ing mitre cuts. For this, push the protective cover
together at the two outer holders and pull it
off toward the front.

Fitting the guide fence

The guide fence can be fi xed on the left- or
right-hand side of the appliance.
♦ Undo both the locking screws on the insertion
openings .
♦ Push the guide fence
openings .
♦ Re-tighten the two locking screws.
Connecting the sawdust extraction
device
♦ Push the extraction nozzle
extraction duct until it is secured.
Optional depending on the diameter of the dust
and sawdust extractor.
PSTDA 18-Li A1
together at the two
and hold it in
it must return to
before connecting
onto the machine
for applications
into the insertion
into the vacuum
♦ Attach an approved dust and sawdust extractor
to the extraction nozzle
Supporting the extraction function:
♦ Slide the sawdust blower switch

Sawdust blowing function

Switching the sawdust blowing function on:
♦ Press the sawdust blower switch

Fitting the splinter guard

The splinter guard can prevent fraying of the
surface while sawing wood. The splinter guard
can only be used for certain saw blade types,
without the sliding shoe
angles of 0°.
♦ Press the splinter guard
baseplate (notch facing upwards).

Fitting the sliding shoe

When working on sensitive surfaces, you can fi t
the sliding shoe on the baseplate
scratching the surface.
♦ Mount the sliding shoe
and press it up at the back until it clicks into
place on the baseplate
♦ To remove the sliding shoe
the rear of the baseplate
forwards.

Operation

Setting the cutting angle

♦ Undo the locking screws
Allen key and pull the baseplate
♦ Adjust the cutting angle to 0°/15°/30°/45°
with the aid of the markings on the baseplate .
Push the baseplate
ing pin engages in the toothing
♦ Re-tighten the locking screws
key.
.
to the rear.
forwards.
and only for cutting
from below into the
to avoid
onto the baseplate
.
, unfasten it at
and slide it off
with the supplied
to the rear.
to the front so that the lock-
.
with the Allen
GB
IE
CY
7