Battery Status; Operation; Stand-Alone Mode; Control Board - EuroLite AKKU UP-1 Glow QCL Flex Spot QuickDMX Bedienungsanleitung

Battery status

The battery charging status is indicated on the display. The battery charging status is indicated by four
levels. If all four levels are lit, the battery is fully loaded. If only one level is lit, the red one, the battery is
going flat soon. In this state, the device can be operated for a few minutes. Then an emergency switch-off
deactivates the device to protect it from total discharge.

OPERATION

After you switch on the device with the power switch, the device starts running. The display lights up and you
can choose the desired mode via the buttons MENU, ENTER, UP, DOWN.
The device has two operating modes. It can be operated in stand-alone mode via the control board and the
EUROLITE IR-13 remote control or in DMX-controlled mode via a standard DMX controller and wireless via
QuickDMX with suitable wireless transmitter.

Stand-alone mode

In the stand-alone mode, you can do without a controller. Disconnect the device from the controller and call
the desired setting. Please refer to the instructions under Control Board.

Control Board

The Control Board offers several features: you can easily set the starting address, run the pre-programmed
program or select a DMX channel mode.
MENU
ENTER
pressing Menu. The functions provided are listed in the following sections.
Menu
Menu level 2
level 1
Addr d001-d512
3CH, 7CH,
CHnd 8CH, 9CH,
11CH
SLAU SL.AU
SP-- SP00-SP99
Pr-- Pr00-Pr30
The main menu is accessed by pressing Menu. Browse through the
UP
menu by pressing Up or Down. Press Enter in order to select the
desired menu. You can change the selection by pressing Up or Down.
DOWN
Press Enter in order to confirm. You can leave every mode by
Description
DMX address setting
Setting DMX channel mode
Slave Mode
Select the desired program speed
S00 – S99 (increasing)
Preset colors
35/48 00112598.DOC, Version 1.0