Troubleshooting - Shimano Serie E6000 Gebrauchsanweisung

Situation where
Code
the error occurred
The speed sensor
may have been
E014
installed in the
wrong position.
A communication
error between the
E020
battery and drive
unit was detected.
A setting error was
E030
detected.
The chain tension
may not have been
adjusted or the
E031
crank may have
been installed in
the wrong position.
Part of the cycle
computer's
E043
firmware may be
damaged.
„ Troubleshooting
Assist function
Symptom
Assistance is not being
provided.
Operational restriction when
an error is being displayed
Power assistance is not
provided during riding.
Power assistance is not
provided during riding.
Power assistance is not
provided during riding.
The assist function is not
available. (Electronic gear
shifting does not function.)
Power assistance is not
provided during riding.
Cause / Possibility
Is the battery sufficiently charged?
Are you riding on long slopes in summer
weather or riding for a long time carrying a
heavy load?
The battery may be overheating.
The drive unit (DU-E6000 / DU-E6001 /
DU-E6050 / DU-E6010), cycle computer
(SC-E6000 / SC-E6010) or assist switch
(SW-E6000) may be connected incorrectly or
there may be a problem with one or more
of them.
Is the speed too high?
Contact the place of purchase or bicycle dealer.
Check that the cable between the drive unit and
battery is properly connected.
If the situation does not improve, contact the place
of purchase.
If the situation does not improve even after
pressing the battery power button and turning on
the power again, contact the place of purchase.
Contact the place of purchase or bicycle dealer.
Contact the place of purchase or bicycle dealer.
Check the battery charge. If the battery is
nearly spent, recharge it.
Turn off the power, wait for a while and
then check once more.
Contact the place of purchase.
Check the Cycle Computer display.
Assistance is not provided at speeds of
25 km/h or more.
39
Remedy
Remedy