Error Messages On The Cycle Computer; List Of Warnings - Shimano Serie E6000 Gebrauchsanweisung

„ Error messages on the cycle computer
WARNING
This disappears if the error is fixed.
Situation where the
Code
error occurred
The chain tension may
not have been adjusted
W031 or the crank may have
been installed in the
wrong position.

List of warnings

Situation where the
Code
error occurred
The temperature of
W010
the drive unit is high.
The traveling speed
W011
cannot be detected.
Condition for removing
the operational restriction
when a warning is being
displayed
The assist function is
not available.
(Electronic gear shifting
does not function.)
Condition for removing
the operational restriction
when a warning is being
displayed
The level of assistance
may decrease.
The maximum speed up to
which power assistance is
provided may decrease.
(Power assistance is provided
up to 25 km/h in top gear.)
37
< SC-E6000 >
Remedy
Contact the place of purchase or bicycle dealer.
Remedy
Stop using the assist function until the temperature of
the drive unit drops.
If the situation does not improve, contact the place of
purchase.
Check that the speed sensor is properly installed.
If the situation does not improve, contact the place of
purchase.
< SC-E6010 >
< SC-E6010 >