Operating Device - Caso C21 Bedienungsanleitung

Operating the device
• Connect the plug to a suitable power outlet.
• The control light of the „Power" button lights up and an audible signal sounds. The device is
now in stand-by mode.
•
Place a suitable cooking pot or pan centrally onto the cooking hob.
• Now press button 1. „Power" to turn on the induction cooker. The device heats up and an
audible signal sounds. Then press button 8. Menu 1x. The wattage display 4. will blink.
• You can use the selection buttons 2. and 3. + / - to adjust the setting in the range 300, 500,
700, 900, 1100, 1300, 1500, 1700, 1900, 2100 watts.
• Then press button 8. Menu again to preset the temperature permanently. The temperature
display 5. will blink.
•
You can use the selection buttons 2. and 3. +/- to adjust the setting in the range 60 – 220°C.
(Temperature levels: 60, 80, 100, 120, 140, 160, 180, 200 and 220 °C)
The temperature is measured by a sensor under the glass-ceramic plate so that the displayed
temperature can differ from the temperature inside the pot.
Please note that the two functions „level" and „temperature" must be selected alternately. You
can either use the power levels or the temperature selection. The most recently selected
function is active and blinks.
• Timer function button: Press 8. Menu 3x.
•
You can use the selection buttons 2. and 3. +/- to adjust the setting in the range 1 – 120
minutes. Selected in 1 minute intervals (up to 120 minutes). The selected duration is then
counted down in the Display in 1 minute steps. When the time has elapsed an audible signal
sounds and the device automatically switches to stand-by mode. Note: During timer operation
the duration can be changed at any time with selection buttons. Due to the device's memory
feature the set temperature level remains unchanged.
• When the induction cooker is set to general heating mode you can press button 7.
Booster to turn on the full power of 2100 watts for the first 30 seconds. After that the
power is reset to the preset level.
• Button 9. Hold: Press „Hold" to lock all functions so that they cannot be changed. By pressing
„Hold" again for 5 seconds all functions are unlocked. This function can be used as a child
protection feature. At the same time it prevents accidentally changing selected settings during
cooking.
• Do not place empty cooking pots or pans onto the ceramic field. Heating an empty pot or
pan activates the overheat protection and turns off the device.
• Do not use the device if it is damaged in any way or does not function properly.
•
The use of accessories and spare parts not recommended by the manufacturer can
result in damaging the devices and injuries.
•
When „E2" or „E6" appears in the display this indicates that the overheat protection was
activated to protect the device and cooking pots.
An activated overheat protection can be reset by unplugging the power cord. The device can
then be used in the normal way.
16