Filter Maintenance - clage Zip HydroTap G4 BC 100/75 Gebrauchsanleitung

LCD Screen operation - Section F
Dispense Times
The ability to change the maximum dispensing time for both the hot
and cold water has been introduced. The default settings for the
maximum dispensing times is 15 seconds. Here, the operator may
change both the hot and cold dispensing times to between 5 and
15 seconds, in increments of 1 second. To edit the dispensing times:
Water Filter
The Zip HydroTap notifi es when fi lter replacement is due. If you
notice one of the following, you will need to change the fi lter.
> The Change Filter LED will fl ash white once a second and remain
so until reset. The fi lter status light is located below the levers on
the tap head assembly.
> The fi lter percentage will show 0% on the Home screen.
Note: Replace the fi lter after a non-use of more than two months,
even if the change interval has not yet been reached!
Note: Depending on local water quality conditions and usage, the
fi lter may require changing anywhere from 500 Ltrs to 10000 Ltrs.
You may also need to replace the fi lter if you notice unpleasant
odours or tastes.
1. Press the [MENU] button for
2. Press the [Setting] button.
3. Press the [Dispense Time]
4. Select the option to change

Filter Maintenance

Some water may drip from the
fi lter head (socket) during re-
placement. Keep a towel handy to
dry up any drips.
41
main menu.
button.
and scroll using the up and
down arrow Keys