Filter Replacement; Other Maintenance - clage Zip HydroTap G4 BCS 160/175 Gebrauchs- Und Montageanleitung

Zip HydroTap ® G4 BCS100/75 und G4 BCS160/175
6. Cleaning and Maintenance

Filter Replacement

If the white LED on the tap flashes, that indicates that the internal filter needs to be
replaced. The filter replacement interval is calculated from the values entered in the
menu under settings / filter for the maximum filter life and the maximum filter capacity
and the consumption values measured by the unit. The filter may have to be replaced
earlier if an unpleasant odour or taste occurs.
Water may drip out of the filter holder during replacement. Have a bucket and cloths
ready to mop up any water that escapes.
1. Close the isolating valve to shut off the water supply.
2. Open the filter door of the undersink unit.
3. Press the red lever on the filter head and turn the filter cartridge one quarter turn
anticlockwise, as far as it will go.
4. Carefully pull the filter cartridge out of the filter holder from below. Hold the cartridge
level to avoid spilling dirty water.
5. Unpack the new filter cartridge and write today's date in the space provided at
the label. Avoid contact with the O-rings and filter opening, as that could result in
bacterial contamination of the filter.
6. Push a new replacement filter cartridge into the filter holder and turn it clockwise as
far as it will go to lock it in position.
7. To flush through the new filter, enable the 'Flush filter' option in the 'Installation'
menu on the unit control panel, as described in the 'Menu' section.
8. To reset the filter consumption meter, choose 'Reset filter' under 'Install' on the
control panel.
9. Dispose of the used filter correctly.

Other maintenance

Regular servicing is needed to keep the unit working efficiently at all times. Please
contact customer service for more information about the servicing of your unit.
30