clage Zip HydroTap G4 BC 100/75 Gebrauchsanleitung Seite 40

LCD Screen operation - Section F
Safety
To allow the safety setting to be changed
1. Press the [MENU] button for
main menu.
2. Press the [Setting] button.
3. Press the [Safety] button.
4. Press button A to allow the
safety setting to be changed.
Safety Lock
5. Press button B to select Enable / Disable
Hot Isolation
The HydroTap is equipped with a safety mode that allows for addi-
tional safety protection, if needed.
To (de-) activate the Hot Isolation
1. Press button C to enable hot isolation.
2. Then tap the safety lock three times rapidly, the LED's will scroll
from right to left three times and the hot isolation will be active.
3. To de-activate, press button C to disable hot isolation.
To operate the tap when in Hot Isolation mode, tap the Safety
Lock three times rapidly, the LED's will scroll from right to left
three times. This operation confi rms de-activation and will remain
de-activated for 30 seconds. The Hot Isolation can be immediately
set again, by tapping the safety lock three times rapidly.
Note: Upon completion, all the settings can be protected by
dis-allowing any setting changes by selecting [NO] on menu A .
40
A
B
C