Cameo STORM FX Bedienungsanleitung Seite 21

OPERATION / BEDIENUNG / UTILISATION / OPERACIÓN / OBSŁUGA / UTILIZZO
EN
A few seconds after connecting to the power supply, the effects projector is ready for operation and the operating mode that was previously
selected is activated. During startup, the software version is briefly displayed (V1.xx).
ACTIVATING THE DMX CONTROL, THE DMX MODE AND DMX START ADDRESS
Press the MODE button repeatedly until the LED indicator for the DMX control lights up (DMX) and "Addr" appears on the display. Now press ENTER
to activate the DMX control and display the currently set DMX start address. If no DMX signal is present, all four characters flash on the display; if a
DMX signal is present, the flashing stops. Press the ENTER button and then use the UP and DOWN buttons as required to select the DMX operating
mode (02Ch, 12Ch). Confirm with ENTER. The currently set DMX start address will be shown on the display and you can use the UP and DOWN
buttons to make adjustments as required (02Ch = 001 - 511, 12Ch = 001 - 501). To confirm, press ENTER. The synchronous control of multiple spot-
lights (same model) through a DMX control unit (e.g. DMX console) can be achieved by selecting the same DMX mode and assigning the spotlights to
an identical DMX start address while connecting them using DMX cables.
-> ENTER -> -> ENTER ->
<- MODE <- MODE
AUTOMATIC CONTROL MODE
Press the MODE button repeatedly until the LED indicator for automatic control (AUTO) lights up and "Aut" appears on the display. Now press ENTER
to activate the DMX control and display the currently set auto program (Aut0 - Aut6). One of the 7 auto programs can now be selected by using the
UP and DOWN buttons. After confirming by pressing the ENTER button, you can now select the speed at which the selected program runs by using
the UP and DOWN buttons (the display shows: S 0 = minimum speed, S 99 = maximum speed). Confirm with ENTER.
-> ENTER -> -> ENTER ->
<- MODE <- MODE
MUSIC CONTROL MODE
Press the MODE button repeatedly until the LED indicator for the Music control mode (SOUND) lights up and displays "Sou". Now press ENTER to
activate the Music control mode and display the currently set program (Sou0 - Sou6). One of the 7 auto programs can now be selected by using the
UP and DOWN buttons. To adjust the sensitivity with which the programs react to sounds, use the Nr 12 controller as desired. When turned to the left,
the sensitivity is lowered, when turned to the right, it is increased.
-> ENTER -> -> ENTER ->
<- MODE <- MODE
SLAVE MODE
Press the MODE button repeatedly until the LED indicator for the Slave mode (SLAVE) lights up and displays "SLAV". If no control signal is present,
the characters on the display flash; the flashing stops as soon as a control signal is present. Connect the slave and the master unit (same model)
using a DMX cable (Master = DMX OUT, Slave = DMX IN) and activate one of the standalone modes (automatic control or music control) on the
master unit. Now the slave unit follows the master unit.
SYSTEM
In the System menu item, the display switch-off and a test program for all functions can be enabled and a reset of all settings can be performed.
Press the MODE button repeatedly until "SYS" appears on the display. Press the ENTER button and then use the UP and DOWN buttons to select the
desired menu item.
-> ENTER -> -> ENTER ->
<- MODE <- MODE
-> ENTER -> -> ENTER ->
<- MODE <- MODE
UP/DOWN
UP/DOWN
UP/DOWN
UP/DOWN
-> ENTER -> -> ENTER ->
UP/DOWN
<- MODE <- MODE
-> ENTER -> -> ENTER ->
UP/DOWN
<- MODE <- MODE
stop
-> MODE
test
-> ENTER
-> ENTER ->
UP/DOWN
<- MODE
-> ENTER
<- MODE
-> ENTER ->
<- MODE
21