Pkm DW9-7FI Bedienungsanleitung Seite 76

 Very low temperature of the water
supply.
 Appliance is overfilled.
 Dishes are placed improperly.
 Old or wet pulvered detergent.
 Rinse aid container is empty.
 Improper detergent dosage.
 Soft water in combination with too
much detergent.
1. Tea or coffee stains.
2. Iron deposits in the water.
 Minerals in hard water.
The cover of the detergent container does not close.
 Setting is not OFF.
 Dishes block the container of the
detergent.
 Normal.
 Aluminium-made objects touched
the dishes.
Cloudiness on glassware.
Yellow or brown film on inner surfaces.
White film on inner surfaces.
Some detergent is left in the container.
Black or grey marks on the dishes.
1. Remove all metal-made objects.
2. Do not use a detergent.
3. Select the longest programme.
4. Start the programme. After 18-22
minutes the main-wash cycle begins.
5. Open the door pour 2 cups of white
vinegar in the appliance (bottom).
6. Close the door and let the complete
programme run. If this measures fail,
repeat the procedure but use 1/4
cup (60 ml) of citric acid crystals
instead of the vinegar.
 If you have soft water, use less
detergent. Select a short programme
for glassware.
1. Clean with a solution of 1/2 cup of
bleach and 3 cups of warm water.
Clean by hand.
2. You need a special filter. Contact a
local water installation company.
 Clean the interior with a soft sponge
and dishwasher detergent. Wear
rubber gloves! Use dishwasher
detergent only to avoid formation of
foam.
 Select setting OFF and push the
door latch to the left.
 Place the dishes properly..
Steam.
 There is some steam coming
through the vent near the door latch
during drying and water draining.
 Clean the marks with a mild abrasive
cleaner by hand.
76