teutonia Mistral S V2 Bedienungsanleitung Seite 13

Attaching and removing the seat or carry-cot
(upper section)
1 1
2 2
Place the upper section (sports buggy seat or carry-cot)
onto the pram chassis in such a way that the lateral
bars 1 of the upper section click into the slots provid-
ed 2 on each side of the chassis and push the upper
section in as far as it will go. The locks then close
automatically. (The locks must „click" into place.)
WARNING:
Check that the pram body or seat unit attach-
ment devices are correctly engaged before use.
The upper section is secure if the red field in the re-
lease lever is no longer visible. To remove the upper
section press the safety lever (3) up and then the
release lever (4) down until the lever locks. (red field
appears). Then pull the upper section out of the slots
and remove it.
How to use the hood
Push the insert pieces for the hood joints into the
corresponding openings on the armrest or on the
carry-cot.
Attention: You must secure the press studs on the
back end of the cover onto the rear of the backrest
as the cover is also used as a protection against
falling out.
If you need to remove the hood, undo the press studs
on the rear of the backrest; press the release buttons
on the insert pieces of the hood joints and pull the
joints out of the openings. You can open the zip at the
top of the hood for ventilation.
Adjusting the back rest
4 3
Adjusting the foot rest
Using the 5-point harness
You can position the shoulder harnesses at 3 levels.
Always use the position closest to the shoulder level
of your child. To open the harness press the central
button on the buckle. To adjust the shoulder/ weist
harness pull the free ends of the strap.
Adjusting the restraints
Pull up on the arrester of
the back rest to change its
inclination angle (4 seating
and prostrate positions +
folding position all the way
forward).
Press and hold the foot rest ar-
rester there are three positions
available for the foot rest.
13