Package, Transport And Storage; Delivery; Transport; Storage - Homa TPM Originalbetriebsanleitung

Furthermore it is possible to check the direction of rotation with a 'motor and phase rotation indicator'. This
measuring device is held towards the engine block of the running pump from externally and shows the direction of
rotation by means of LED.
Automatic float switch
The float switch is directly connected to the pump cover. An additional float cable is not necessary.
By directly connecting the float switch in the pump, the pump turns on automatically if this
switch is triggered manually! Therefore, make sure that the pump is not connected if you are working on
the float.
3.3.4. Seal / Seal housing
The seal is created by one lip seal and one mechanical seal (silicon carbide) in tandem arrangement.
3.3.4. Pump casing
The pump casing is available with different pressure discharges, depending on version and engine variation. This
creates an optimal connection to the various types of pipework.
TPV3.../ CPV3...
TPM3.../ CPM3...
TPV5.../ CPV5...
TPM.../ CPM5...
3.3.5. Impeller
The impeller is fixed on the engine shaft which powers it. For the M version, the impeller is an open single-blade
wheel, which is suitable for sludge-type media containing solids or fibrous admixtures.
The free-flow impeller is used for the V version. This is suitable for gas- or air-containing media with rough or
fibrous, stringy components.
The free flow depends on the pump type:
TPV3.../ CPV3...
TPM3.../ CPM3...
TPV5.../ CPV5...
TPM.../ CPM5...
4. Package, Transport, Storage

4.1. Delivery

On arrival, the delivered items must be inspected for damage and a check made that all parts are present. If any
parts are damaged or missing, the transport company or the manufacturer must be informed on the day of
delivery. Any claim made at a later date will be deemed invalid. Damage to parts must be noted on the delivery or
freight documentation.

4.2. Transport

Only the appropriate and approved fastening devices, transportation means and lifting equipment may be used.
These must have sufficient load bearing capacity to ensure that the product can be transported safety. If chains
are used they must be secured against slipping.
The personnel must be qualified for the tasks and must follow all applicable national safety regulations during the
work.
The product is delivered by the manufacturer/shipping agency in suitable packaging. This normally precludes the
possibility of damage occurring during transport and storage. The packaging should be stored in a safe place if
the location used is changed frequently.

4.3. Storage

Newly supplied products are prepared that they can be stored for 1 year. The product should be cleaned
thoroughly before interim storage.
The following should be taken into consideration for storage:

Place the product on a firm surface and secure it against falling over. Submersible mixers and
auxiliary lifting devices should be stored horizontally, submersible sewage pumps and submersible
motor pumps should be stored horizontally or vertically. It should be ensured that they cannot bend
if stored horizontally.
38
G 1 ½ A
G 1 ½ A
G 2 A
G 2 A
30mm
30mm
50mm
50mm