Installation - Electrolux EON3410 Benutzerhandbuch

22 www.electrolux.com
The oven lamp does not
operate.
The display shows 12.00. There was a power cut.
Steam and condensation
settle on the food and in
the oven.
If you cannot find a solution to the prob-
lem yourself, contact your dealer or the
service centre.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

11. INSTALLATION

WARNING!
Refer to the Safety chapters.
11.1 Building Under
WARNING!
Only a qualified and competent
person must do the installation of
the appliance. If you do not con-
tact a qualified or competent per-
son, the guarantee becomes inva-
lid if there is damage.
• Before you install the appliance, fit it
with the applicable hob from the table.
Type
EHA6040
EHA6046
11.2 Electrical connection with
the hob
The hob connection socket is at the top
of the oven cabinet. The hob has connec-
tion leads for the cooking zones and the
ground cable. The leads have plug-in
connectors. To connect the hob to the
oven, plug the connectors into the correct
oven sockets. The design of the plugs
Problem
Maximum power
6500 W
7600 W
Possible cause
The oven lamp is defec-
tive.
You left the dish in the
oven for too long
The necessary data for the service centre
is on the rating plate. The rating plate is
on the front frame of the appliance cavity.
and sockets prevents incorrect connec-
tions.
573
Remedy
Replace the oven lamp.
Set the clock.
Do not keep the dishes in
the oven for longer than
15 - 20 minutes after the
cooking ends.
.........................................
.........................................
.........................................
558
5
min. 550
20
600
min. 560
548
20
589
594