Adapter For External Vacuum Extraction (With Reducer Piece); Attaching / Detaching Sanding Sheets; Turn The Backing Plate In 60° Steps; Advice On Use - Parkside PDS 290 A1 Betriebsanleitung

Preparing for use / Maintenance and cleaning
Always pull the mains plug is
out of the socket before doing any work on the
device.
Adapter for external vacuum
Q
extraction (with reducer piece)
Connection:
P ush the adapter for external vacuum extrac-
tion into the dust extraction spout
7
When doing this observe the guide markings
on the device and adapter. Turn the suction
nozzles clockwise to lock.
I f it is necessary to use the reducer piece
push the reducer piece into the adapter for
external vacuum extraction
P ush the hose of a suitable dust extraction de
vice approved for that purpose (e.g. a workshop
vacuum cleaner) on to the adapter for external
vacuum extraction
Removal:
P ull the hose of the dust extraction device off
the adapter for external vacuum extraction
Turn anticlockwise to unlock the dust extraction
port .
4
P ull off the adapter for external vacuum extrac-
tion (with the reducer piece
7
Attaching / detaching
Q
sanding sheets
Always pull the mains plug is out
of the socket before doing any work on the device.
Attaching:
S anding sheets are attached to the backing plate
by means of the hook and pile fastening.
6
Detaching:
S imply pull the sanding sheet off the backing
plate (see Fig. B).
6
Materials:
Wood (sanding sheets included), paint*, stone*
*depending on the sanding sheet
10 GB/IE/CY
.
4
8
.
7
or the reducer piece
7
if used).
8
Turn the backing plate
Q
in 60° steps
of the socket before doing any work on the device.
T urn the backing plate
in 60° steps until it engages in the desired
position (see Fig. C).
Sanding output and surfaces:
The shape of the delta sander allows you to sand
workpieces even in their difficult to access places,
corners and edges (see Fig. D).
Sanding performance and surface quality depend
, on the grade of sanding sheet and the oscillation
speed setting.
A lways use sanding sheets with grades that
are suitable for the particular surface you are
sanding. The speed selected should also be
appropriate to the task undertaken.
.
8

Advice on use

Q
. S witch the device on before placing it against
7
the workpiece.
A pply light sanding pressure only.
A dvance the device at an even rate.
C hange sanding sheets at the appropriate time.
D o not work on different types of material using
the same sanding sheet (e.g. wood and then
metal). To achieve the best sanding results you
should use unworn, undamaged sanding sheets.
C lean the sanding sheet from time to time with
a vacuum cleaner.

Maintenance and cleaning

Q
of the socket before doing any work on the device.
The delta sander is maintenance-free.
C lean the device frequently. This should be done
immediately after you have finished using it.
F or cleaning the housing use a dry cloth only.
R emove any adhering sanding dust with a nar-
row paint brush.
Always pull the mains plug out
of the delta sander
6
Always pull the mains plug out