Safety Instructions Specifi Cally For Cordless Screwdrivers; Original Accessories/Additional Equipment; Before Fi Rst Use; Charging The Rechargeable Battery On The Device (See Fig. C) - Parkside PAS 7.2 A1 Betriebsanleitung

Safety instructions specifi cally for
cordless screwdrivers
■ Immobilise the workpiece securely. A
workpiece that is held in place with a clamp/
vice can be worked much more safely than a
workpiece held with the hand.
■ Hold the power tool fi rmly. When tightening or
loosening screws, a high reaction moment can
quickly occur.
■ Switch off the power tool immediately if the
tool being used gets blocked. Be prepared
for high reaction moments as these can cause
kick-back.
■ Hold power tool by insulated gripping surfaces,
when performing an operation where the
fastener may contact hidden wiring or its
own cord. Fasteners contacting a "live" wire may
make exposed metal parts of the power tool
"live" and could give the operator an electric
shock.
■ When working on the appliance, as well as
during transport and storage, always place
the rotation direction switch in the middle
position (locked). This will prevent unintentional
activation of the device.
■ This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabili-
ties or lack of experience and knowledge if
they have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved. Children
must not play with the appliance. Cleaning and
user maintenance tasks must not be carried out
by children unless they are supervised.
Original accessories/additional
equipment
■ Use only the additional equipment and acces-
sories detailed in the operating instructions.
The use of tools and accessories other than
those recommended in the operating instruc-
tions could lead to an increased risk of personal
injury for you.
PAS 7.2 A1
Before fi rst use
Charging the rechargeable battery
on the device (see Fig. C)
NOTE
► The battery is supplied partially charged.
Before fi rst use, charge the battery for at least
3 hours. Li-ion batteries can be charged at
any time without adversely aff ecting their
service life. Interruption of the charging
process will not damage the battery.
Starting the charging process:
♦ Connect the Battery charger
50 Hz mains socket.
♦ Connect the Battery charger
socket on the device
The rechargeable battery is charged when all three
LEDs in the battery display
LED indications:
red: beginning charging process
red/ orange: battery partly charged
red/ orange / green: battery charged
Ending the charging process:
♦ Disconnect the Battery charger
mains socket.
♦ Disconnect the Battery charger
charging socket on the device
Changing the bits /
screwdriver bits inserts
Insertion:
♦ Insert the bit directly into the tool holder
Removal:
♦ Pull out the bit out of the tool holder
to a 230 V ∼
to the charging
.
are lit.
from the
from the
.
.
.
13
GB