IKEA SVALKAS Gebrauchsanleitung Seite 15

ENGLISH
Problem
There is too much frost and
ice.
Water flows on the rear
plate of the refrigerator.
Water flows inside the re-
frigerator.
The temperature in the ap-
pliance is too low/too high.
Possible cause
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not
wrapped properly.
Temperature is set incor-
rectly.
During the automatic de-
frosting process, frost melts
on the rear plate.
The water outlet is clog-
ged.
Food products prevent
that water flows into the
water collector.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been
opened often.
Solution
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products bet-
ter.
Refer to "Operation" chapter.
This is correct.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
15