Before The First Operation; Safety Cut-Out; Cleaning And Maintenance - EFBE-SCHOTT wk 600 Gebrauchsanleitung

Fax +32 2 359 95 50

BEFORE THE FIRST OPERATION

For the perfect taste, operate the jug kettle with fresh water in order to clean any residue left
from the manufacturing process. When the appliance has cooled down, repeat the process 3
times with fresh water, before rinsing.
OPERATION
•
Always remove the jug from the power base before filling it or before any operation.
•
Open the lid by pressing its release button and fill the tank with fresh water, paying
attention not to fill under the minimum mark or above the maximum mark on the water
level indicator.
•
Close the lid by pressing it down until you hear a click. Make sure it closes correctly.
•
Put the jug onto the power base, plug into the wall socket and switch on by pressing down
the switch to position "I".
•
The jug kettle will switch off automatically when the water is boiling. However, you can stop
the jug kettle anytime by pressing its switch upwards or by taking the jug from the power
base.
•
For instant reboiling, wait until the water has cooled down and switch on the appliance
again.

SAFETY CUT-OUT

•
This jug kettle is protected with an automatic safety device which switches the appliance
off automatically if it is accidentally switched on without water.
•
In this case, switch off the appliance and wait about 10 minutes for the element to cool.
Then fill the jug kettle with cold water. This will reset the safety device.
•
The kettle may then be used as normal.
•
Should the problem persist, contact the nearest customer service.

CLEANING AND MAINTENANCE

•
Before attempting any cleaning operation, make sure the appliance is unplugged from
the supply socket and fully cooled down.
•
To clean the exterior surfaces, simply wipe over with a soft damp cloth and dry thoroughly.
Scale on the interior surfaces can be removed with a soft brush.
•
Never use abrasive products.
•
On no account must the jug kettle or its power base be immersed in water.
•
When the lid is open, you can remove the particle filter by pulling at it and you can clean
it under running water.
DESCALING
When scale becomes visible in the jug, you have to descale it. To remove scale from the jug
kettle, use products made especially available for this purpose, liquid descaling products or for
the sake of environmental protection you can use vinegar.
When descaling, please pay attention to the following points:
•
First pour some water in the appliance, and add the descaling product afterwards.
• Make sure to dilute the product sufficiently. Please follow the instruction manual of the
descaling product.
•
When using vinegar, do not use more than 2-3 ml.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
- 8 -
Assembly page 8/16
WK 600 – 081222