Pkm WA6-E1512 Bedienungsanleitung Seite 37

The ECO-function increases the main washing time to upgrade the washing
effects.
1. Select Koch/Buntwäsche (coloureds/boil wash) and a temperature of 40
0
60 C. You can activate the ECO-function in these settings only.
2. Press Schleuderzahl (speed) and Temp. for 3 seconds simultaneously until the
display indicates ECO.
Separate spinning function. Drain water before selecting the spinning function.
For cleaning the drum and pipes/hoses. Temperature is 90
laundry! Operate the programme regularly.
Setting of delayed start (0-24 h):
1. Select a programme.
2. Press the Zeitvorwahl (delay) button and select the desired time-delay.
3. Press the START/PAUSE button.
To cancel the time-delay press the Zeitvorwahl (delay) button until the indicator
goes off. Press the Zeitvorwahl (delay) button until the display indicates 0 h. In
case of a mains failure the appliance has saved the set time delay and starts the
countdown at the point the energy was shut off as soon as the energy supply is
active again.
Locks all buttons except the POWER button. Press ZEITVERZÖGERUNG and
SCHLEUDERZAHL simultaneously for 3 seconds while the appliance is
operating. You will hear an acoustic signal. The rotary knob and the
START/PAUSE button are locked. Repeat the procedure to unlock the
knob/buttons.
When you stop operation with the POWER button, the appliance saves the locked
setting; as soon as you start operation again, the lock is also active.
When a programme has finished the child lock is not deactivated.
In case of a mains failure the child lock is deactivated.
If you use too much detergent a strong formation of bubbles may occur, which
will have a negative effect on the proper operation of the appliance. The appliance
starts this function automatically as soon as a certain amount of bubbles is
detected. In such a case use less detergent when operating the particular
programme the next time.
To deactivate the acoustic signal press TEMP for 3 seconds when the appliance is
operating. You will hear a beep once to confirm the deactivation. Repeat the
procedure to reactivate the acoustic signal.
The acoustic signal stays deactivated until you have reactivated it.
Schleudern (spinning)
Trommelreinigung (drum cleaning)
Zeitvorwahl (delay)
Child lock
Automatic function for bubble-reduction
Deactivating of the acoustic signal
ECO
37
0
C. Do not add any
0
or