Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation
Operating conditions
Prior to transportation, allow the machine to cool down and completely empty the tank.
Never operate the fog machine without fog fluid. Fire hazard due to overheating! Besides, the unit may
be damaged.
During operation smoke emission may stop. In this case the device is heating up again. After a short
period, the machine will be ready to emit fog again. This process guarantees an appropriate
vaporization temperature and the best fog emission possible. The temperature is regulated by a high-
quality thermostat.
• Prior to switching on, check the fluid level of the tank and fill up fog fluid, if required.
• Connect the machine to the mains with the power plug.
• The machine does not feature a power switch. When the machine is connected to the mains it is powered on
and starts the warm-up process. The display indicates "HEAT". While the machine is warming up, fog output will
not be possible yet. Once the warm-up process is completed, the display indicates the standard screen and
and fog output will be possible; either via the rotary controls or via DMX.
Adjusting the fog output volume
Use the VOLUME control to adjust the fog output volume: 0 = no output, 100 = maximum output. The display
shows the current value.
Adjusting the fan speed
Use the FAN control to adjust the fan speed: 0 = fan off, 100 = maximum speed. The display shows the current
value.
Notes
• All fog machines may sputter small amounts of fog occasionally during operation and for a minute or so after
being turned off.
• All fog machines have a recycling period after long bursts when the machine will shut itself down for a short
period in order to heat up again. During this time no fog can be produced.
CAUTION!
16 • EN
Werbung
Kapitel
Inhaltsverzeichnis
