Cleaning The Transport Rollers; Troubleshooting - Olympia TBL 1300 Combo Bedienungsanleitung

7.2

Cleaning the transport rollers

Deposits and residual adhesive on the transport rollers can influence the
results of the laminating process. Therefore, clean the transport rollers at
regular intervals:
1. Wait until the Laminator LED lights up red continuously.
2. Insert a piece of folded paper in the laminator infeed.
3. Repeat the process with a new piece of paper until there are no more
deposits or residual adhesive to be seen on the paper.
8

Troubleshooting

Problem
POWER indicator
does not light up.
Laminated foil is
not completely
transparent
Foil jam
Device no longer
works after a
longer period in
operation or stops
during operation.
Transport rollers do
not run.
Diagnosis & Cause
The power plug is not
plugged into the power
socket properly.
The device was not switched
on.
The POWER ON/OFF LED
is defective.
The laminating temperature
was too low.
The lamination foil was
inserted askew in the
laminator infeed.
The lamination foil is too
large.
Is the surface of the device
hot? If so, the device's
overheating protection has
probably switched the
laminator off automatically.
The power plug is not
plugged into the power
socket properly.
The device was not switched
on.
27
Solution
Connect the power plug in
the power socket properly.
Press the POWER button
until the POWER LED lights
up red.
Contact our hotline (refer to
Chapter "Guarantee").
Laminate the same foil
again to improve the
lamination result.
Refer to Section "Clearing
jammed lamination foil".
Refer to Section "Cleaning
the transport rollers".
Insert the lamination foil in
the laminator infeed straight
and with the closed side
first.
Only use lamination foil of
the specified sizes, refer to
Chapter "Technical Data".
Wait for approx. 30 minutes
and try to laminate again. If
the device does not work,
contact our hotline (refer to
Chapter "Guarantee").
If the problem continues,
contact our hotline (refer to
Chapter "Guarantee").