Cleaning And Servicing; Troubleshooting; Warranty - Olympia A-270 Bedienungsanleitung

Cleaning and Servicing

Deposits and residual adhesive on the transport rollers can influence the re-
sults of the laminating process. Therefore, the transport rollers must be
cleaned periodically after use:
To do this, insert a folded piece of paper in the insertion slot. Residual adhe-
sive is removed and taken up by the paper when ejected. Repeat the proc-
ess several times.
Disconnect the power plug before starting to clean the unit with a damp
cloth. If necessary, the housing can be cleaned using a cloth moistened with
clean water with a little mild soap applied. Never use any solvents or ag-
gressive cleaning agents.

Troubleshooting

Fault
• Red LED (Power) does not light up
• Unit does not respond
• Foil jam
• Laminated foil is not completely
transparent

Warranty

In the case of a defect, please return the device together with the receipt and
original packing material to the point-of-sale.
Corrective measures
• Check that the power plug has
been properly connected to the
power socket.
• If the fault cannot be cleared, con-
tact our hotline.
• Check the foil pockets being used
are the correct size.
• Only use pouches of the size speci-
fied.
• Ensure that the pouch has been in-
serted correctly in the unit.
• To clear the fault, follow the instruc-
tions in the Section "Clearing Foil
Jams".
• Laminate the same foil again to im-
prove the lamination result.
Conformity of the equipment to the
EU directives is confirmed by the
CE symbol.
14