Overheating Protection (Auto Off); Cleaning & Maintenance; Cleaning The Exterior Of The Device - Olympia TBL 1300 Combo Bedienungsanleitung

8. The Bind/Counter LED flashes red during the binding process. The
binding process is completed after about 1 minute and the Bind/Counter
LED lights up green continuously. Three acoustic signals also indicate
that the thermal binding process has finished.
Caution: The bound folder is very hot in the spine area after binding!
9. Remove the thermal binding cover and place it on the cooling device for
about 10 minutes.
Note: Observe the cooling down time. Too short a cooling down time
will result in loose sheets!
10. Repeat steps 1 to 9 to bind further documents.
11. When you have finished thermal binding, switch the device off and
disconnect the mains plug from the power socket. Let the device cool
down before packing it away, for example.
6.3.2

Overheating protection (auto off)

The device is equipped with an overheating protection (Auto off) in order to
protect thermal binding covers which have not been removed from
overheating.
An acoustic signal indicates the binding process has finished. The
overheating protection is activated at the same time. If the Thermal Binding
button is not pressed for a period of 90 minutes, the power supply is cut off
electronically (Auto off).
To start thermal binding, the device must be switched on again, refer to
Section "Switching the device on and off".
7 Cleaning & Maintenance
7.1

Cleaning the exterior of the device

Attention: Before cleaning the device with a damp cloth, disconnect
the power plug!
Clean the housing using a cloth moistened with clean water with a little mild
soap applied.
Note: Never use solvents or aggressive cleaning agents.
26