Operation; Switching The Device On And Off; Laminator; Cold Laminating - Olympia TBL 1300 Combo Bedienungsanleitung

Safety note: The power socket must be in the immediate vicinity of
the device and easily accessible. This enables you to disconnect the
device from the power supply quickly in an emergency.
6

Operation

6.1

Switching the device on and off

1. Press the POWER button. The POWER LED lights up red. The device is
switched on.
2. Press the POWER button. The POWER LED goes out. The device is
switched off.
6.2

Laminator

The laminator can complete hot and cold lamination:
In the case of cold lamination, the lamination foil is pressed together.
●
In the case of hot lamination, the lamination foil is adhered together.
●
Select the lamination method according to the material to be laminated.
Note: Only cold lamination should be used for thermopaper and
ultrasonic images!
6.2.1

Cold laminating

1. Ensure that the device is switched on, refer to Section "Switching the
device on and off".
2. Press the Laminator button until the Laminator LED lights up green.
When the Laminator LED lights up green continuously, the device is
ready for use for cold lamination.
Attention: If you have just finished using the laminator for hot
laminating, you must let the laminator cool down. The Laminator LED
flashes green when the device is cooling down. It takes a few minutes
to cool down sufficiently.
Note: Only use cold lamination foil for cold laminating.
3. Remove the protective foil from the foil pocket.
4. Insert the document to be laminated in the lamination foil pocket so that
there is a margin of approx. 3 - 5 mm to the edge of the foil on all sides.
23