Hot Laminating - Olympia TBL 1300 Combo Bedienungsanleitung

5. Guide the laminating foil pocket containing the document to be laminated
in the laminator infeed straight and with the closed side first. The
laminating process occurs automatically.
Note: To prevent the lamination foil from creasing, never feed the
open side of the lamination foil pocket first in the laminator infeed.
When inserting the lamination foil pocket, observe the instructions on
the infeed slot.
6.2.2

Hot laminating

1. Ensure that the device is switched on, refer to Section "Switching the
device on and off".
2. Press the Laminator button until the Laminator LED lights up red. The
Laminator LED flashes red when the device is warming up. The correct
operating temperature is reached after about 3 to 5 minutes and the
Laminator LED lights red continually.
Note: Only use hot lamination foil for hot laminating.
3. Insert the document to be laminated in the lamination foil pocket so that
there is a margin of approx. 3 - 5 mm to the edge of the foil on all sides.
4. Guide the laminating foil pocket containing the document to be laminated
in the laminator infeed straight and with the closed side first. The
laminating process occurs automatically.
Note: To prevent the lamination foil from creasing, never feed the
open side of the lamination foil pocket first in the laminator infeed.
When inserting the lamination foil pocket, observe the instructions on
the infeed slot.
Caution: The lamination foil is very hot and soft when ejected
following lamination. Therefore, handle the laminated document with
due care!
Note: To flatten and smoothen the laminated product, place a book or
similar heavy, flat object on it.
5. When you have finished laminating, switch the device off and disconnect
the mains plug from the power socket. Let the device cool down before
packing it away, for example.
Caution: The device is very hot directly after laminating! Risk of
injury!
24