Important Safety Information; Safety Information, Laminator - Olympia TBL 1300 Combo Bedienungsanleitung

1

Important Safety Information

Please observe the following to ensure the device is used reliably and
safely:
Read this operating manual thoroughly and observe the instructions and
●
information in it when operating the device.
Keep this operating manual in a safe place for future reference.
●
The device may only be used in dry, indoor rooms.
●
Before starting to use the device, set it down on a level, stable working
●
base.
Never touch the power plug with wet hands.
●
Disconnect the power plug when the device is not in use.
●
Prevent damage to the power plug and power cable. Never twist the
●
power cable. Do not operate the device if the power cable or power plug
is damaged.
Do not use the device in the vicinity of hot surfaces or in damp
●
environments and protect it from direct sunlight and dusty conditions.
Children must not be allowed in the vicinity of the device when it is
●
ready to operate.
Always switch the device off immediately if it emits a strong smell or it is
●
not in operation.
Disconnect the power plug before starting to clean the device. Never
●
use any solvents or aggressive cleaning agents.
Repairs may only be carried out by properly trained specialists. Failure
●
to observe this may result in fatal injury and there are no rights to claims
under the terms of guarantee.
1.1

Safety information, laminator

The surface of the equipment becomes hot during hot laminating.
●
Only insert lamination foil intended for the device, refer to Chapter
●
"Technical Data". Using lamination foil which is too large could lead to
the unit jamming.
Never cut lamination foil to size. The resulting cut edges could cause
●
the lamination foil to jam.
Do not use lamination foil intended for cold lamination for hot lamination.
●
This could damage the device, lamination foil and document.
19