Specifications - ESX X-TWO Benutzerhandbuch

MODELS
CHANNELS
CIRCUIT
OUTPUTPOWER RMS 13,8 V
Watts @ 4 Ohms
Watts @ 2 Ohms
Watts @ 4 Ohms mono bridged
OUTPUTPOWER MAX. 13,8 V
Watts @ 4 Ohms
Watts @ 2 Ohms
Watts @ 4 Ohms mono bridged
Frequency Range –3dB
Damping Factor
Signal-to-Noise Ratio
Channel Separation
THD&N
Input Sensitivity
Input Impedance
Speaker Impedance
CH 1 & CH 2
X-Over Modes
Various Highpassfilter
Various Lowpassfilter
Bass Boost @ 45 Hz
CH 3 & CH 4
X-Over Modes
Various Highpassfilter
Various Lowpassfilter
Bass Boost @ 45 Hz
Cinch/RCA Outputs
Fuse Ratings
Dimensions
Width & Height
Length (Length total)
Technical specifications are subject to change! Errors are reserved!
For damages on the vehicle and the device, caused by handling errors of the device, we can't assume liability.
All ESX Amplifiers are tagged with a individual serialnumber, which will be registerd for statistic and service conditional purposes.
All ESX Amplifiers are tagged with a E-Certification Number and also a CE-Certification Mark. Thereby these devices are ceritified
for the use inside vehicles inside the European Union (EU).
WARRANTY DISCLAIMER
The limited warranty comply with legal regulations. Failures or damages caused by overload, improper use or by using the
product for competitions are not covered by the warranty.
Please return the defective product only with a valid proof of purchase and a detailed malfunction description.

SPECIFICATIONS

ESX X-TWO ESX X-FOUR
2 4
CLASS A/B CLASS A/B
Analog Analog
2 x 100 4 x 75
2 x 175 4 x 125
1 x 350 2 x 250
2 x 200 4 x 150
2 x 350 4 x 250
1 x 700 2 x 500
10Hz - 50 kHz 10Hz - 50 kHz
>300 >200
>104 dB >104 dB
74 dB 74 dB
<0,05% <0,05%
6 - 0.2 V 6 - 0.2 V
47 kOhm 47 kOhm
2 - 16 Ohm 2 - 16 Ohm
LP/BP - HP - Full LP/BP - HP - Full
15 - 250 Hz 10 - 150 Hz
30 - 250 Hz 30 - 150 Hz
0 - 12 dB 0 - 12 dB
– LP/BP - HP - Full
– 10 - 150 Hz
– 30 - 150 Hz
– 0 - 12 dB
Fullrange Fullrange
2 x 20 A 2 x 30 A
200 x 51 mm 200 x 51 mm
260 (270) mm 260 (270) mm
29
25
26