Herunterladen Inhalt Inhalt Diese Seite drucken

Safety Notices For Chargers - AEG AG 1208 Anleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 3

Safety notices for chargers

Keep the device away from children Children do not understand or perceive
possible risks when handling electrical devices Children must be supervised to
ensure that they do not play with the charger
ensure that the device is always stored in a safe place do no expose the device
to rain or wet conditions avoid pouring or dripping water or other liquids over
it If water penetrates electrical devices, the risk of electric shock increases
ensure that all plugs and cables are free of moisture never connect the device
to the mains with wet or moist hands
never touch battery terminals or battery clamps whilst the device is connected to
alternating current
remove all device cables from the battery before attempting to drive your
vehicle
always disconnect the device from the mains when you are not using it
always disconnect the device by pulling out the power plug, never by unclam-
ping a connecting cable
If the cables need to be run through walls with sharp edges, for example metal
sheets, use tubes or cable ducts to prevent damage to the cables lay electrical
cables in such a way that it is not possible to stumble over them, thereby preven-
ting damage
never place the device over or close to the battery to be charged Gases from
the battery make the charger corrode and damage it set up the charger as far
away from the battery as the direct current cable allows
do not cover the device while charging
never pull the cable or use it to carry the device damaged cables increase the
risk of electric shock
only operate the device if all cables and the casing are intact
If the supplied cables are damaged they must be replaced by qualified specia-
lists to prevent hazards
never operate the device if it has been dropped or damaged in any other way
for inspection and repair, take it to a qualified electrician
all maintenance work must be conducted by qualified electricians
never disassemble the device In correct assembly may cause electric shock or
fire
GB
21

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ag 1212Ag 1210

Inhaltsverzeichnis