Unit Description; Initial Use; Mains Connection - Beurer TL 70 Gebrauchsanweisung

General notes
Important
• If you are taking medication such as pain relievers, antihypertensives or antidepressants, consult your
doctor before using the daylight lamp.
• People with retinal diseases as well as diabetics need to be examined by an ophthalmologist before be-
ginning to use the daylight lamp.
• Please do not use if you have an eye disease such as cataracts, glaucoma, diseases of the optic nerve in
general and inflammation of the vitreous humour.
• If you have health concerns of any kind, contact your general practitioner!
• Before you use the unit for the first time, remove all packaging materials.
• The lamp tubes are excluded from the warranty.
Repairs
Important
• Do not open the device. Please do not attempt to repair the unit yourself. This could result in serious inju-
ries. Failure to observe this regulation shall void the warranty.
• If you need to have the unit repaired, contact customer service or an authorised dealer.

4. Unit description

Overview
1. Fluorescent screen
2. Rear of the device housing
3. On/Off button
4. Mains part connector
5. Timer adjustment „- / +"
6. Timer LED display
7. Brightness adjustment (dimmer)

5. Initial use

Take the device out of the plastic wrapping. Check the device for damage or faults. If you notice any damage or
faults on the device, do not use it and contact customer services or your supplier.
Positioning the device
Place the device on an even surface. The position should be chosen to ensure a distance of between 20 cm and
60 cm between the user and the device. The lamp is most effective at this distance.

Mains connection

• To prevent possible damage to the device, the brightlight must only be used with the mains part de-
scribed here.
• Insert the mains part into the connection provided for this purpose on the rear of the brightlight. The
mains part must only be connected to the mains voltage that is specified on the type plate.
• After using the brightlight, unplug the mains part from the mains socket first and then disconnect it from
the brightlight.
Note:
• Ensure that there is a socket near the place where the lamp will stand.
• Lay the mains cable in such a way that no one can trip over it.
1
5
6
11
7
2
3
4