Safety Warnings - Online USV XANTO S-Serie Benutzerhandbuch

S A F E T Y W A R N I N G S
2.

Safety warnings

This handbook contains important instructions that you must comply
with during the installation and maintenance of the UPS system and
the batteries. Please read these instructions completely before you
begin working with the device. Keep this manual for future reference.

The UPS system conducts life-threatening voltages. All repair
and maintenance work should only be performed by customer
service professionals

The UPS system is permanently connected to the low volt-
age distribution board. A separate circuit breaker is needed
(see Electrical Installation)

The UPS system has its own energy supply (batteries). The
output of the UPS system can conduct voltage even when
the UPS system is not connected to an AC power source

To reduce the risk of fire or an electric shock, the UPS
system may only be installed in buildings with controlled
temperature and air humidity in which there are no conduct-
ing contaminants present. The ambient temperature may not
rise above 40°C. The UPS system may not be operated near
water or in extremely high humidity (>95%)

When installing optional battery modules into a rack, the in-
stallation should occur directly below the UPS system so that
all cables between the housings can be run behind the front
cover (XANTO S 6000) or on the rear side (XANTO S 10000)
and not accessible to the user. A maximum of four battery
modules per UPS system can be installed

Make sure that the UPS system is switched off and discon-
nected from the power supply before transporting the UPS
system
XS6000+XS10000_manual_ger_eng_it_V1.1.1.doc
CAUTION
80 / 216
R. Kistler