Zanussi ZGL643IT Benutzerinformation Seite 15

damage to property caused by failure to obey these re-
quirements.
• To prevent the risks of structural damage or physical
injury, installation, connection of the appliance to the
power supply and gas system, setting up and mainte-
nance must only be done by qualified personnel in
compliance with standards and local regulation force.
• Make sure that the appliance is not damaged because
of transport. Do not connect a damaged appliance. If it
is necessary, speak to the supplier.
• Only use built-in appliances after you assemble the ap-
pliance into correct built-in units and work surfaces
that obey the standards.
• Do not install the hob over a domestic appliances if the
installation instructions do not allow it.
• Install the appliance only on a worktop with flat sur-
face.
• Do not change the specifications or modify this prod-
uct. There is the risk of injury and damage to the appli-
ance.
• Fully obey the laws, ordinances, directives and stand-
ards in force in the country where you use the appli-
ance (safety regulations, recycling regulations, electri-
cal safety rules etc.)
• Keep the minimum distances to other appliances and
units.
• Install anti-shock protection, for example install the
drawers only with a protective panel directly below the
appliance.
• Prevent damage of the cut surfaces of the worktop
against moisture with a correct sealant.
• Seal the appliance to the worktop with no space left
with a correct sealant.
• Prevent damage to the bottom of the appliance from
steam and moisture, e.g. from a dishwasher or oven.
• Do not install the appliance adjacent to doors and be-
low windows. Hot cookware can be hit off the hob
when you open the doors or windows.
• Before installation, make sure that the local supply
conditions (gas type and pressure) agree with the ad-
justment of appliance. The adjustment conditions for
the appliance are on the rating plate, which you can
find near the gas supply pipe.
• This appliance is not connected to a combustion prod-
ucts evacuation device. It must be installed and con-
nected in accordance with current installation regula-
tions. Particular attention must be given to the relevant
requirements regarding ventilation.
• The use of a gas cooking appliance cause heat and
moisture in the room in which it is installed. Make sure
that the ventilation in the kitchen is good: keep natural
ventilation holes open or install a mechanical ventila-
tion device (mechanical extractor hood).
• More ventilation (for example opening of a window or
increasing the level of mechanical ventilation where
present) is necessary when you operate the appliance
with intensity for a long time.
• Carefully obey the instructions for electrical connec-
tions. There is the risk of injury from electrical current.
• Disconnect the appliance from the electrical supply,
before you do the maintenance work or you clean it.
• The electrical mains terminal is live.
• Make electrical mains terminal free of voltage.
• Install correctly to give anti-shock protection.
• A loose and incorrect mains plug and socket connec-
tions can make the terminal become too hot.
• A qualified electrician must install the clamping con-
nections correctly.
• Use a strain relief clamp on cable.
• Use the correct mains connection cable and replace the
damaged mains cable with applicable cable. Speak to
your local Service Force Centre.
• The appliance must have the electrical installation
which lets you disconnect the appliance from the
mains at all poles with a contact opening width of min-
imum 3 mm.
• If the fixing bracket is near to the terminal block, al-
ways make sure the connection cable does not come in
contact with the edge of the bracket.
• You must have correct isolation devices: line protect-
ing cut-outs, fuses (screw type fuses removed from the
holder), ground leakage trips and contactors.
Disposal of the appliance
• To prevent the risk of physical injury or damage
– Disconnect the appliance from the power supply.
– Cut off the mains cable where it connects with the
appliance and discard it.
– Flat the external gas pipes if there are fitted.
– Speak to your local authorised facilities for disposal
of your appliance.
15