Taking Off The Ceiling Cover Plate In An Emergency (Only For Trained Staff); Adjusting The Stop Positions Of The Lift - Kindermann Deckenlift compact2 80 Installationsanleitung

The optional ceiling cover plate with T-profile frame (7466000 152) or inserting the ceiling cutout
(600 x 600 mm, maximum thickness 15 mm, maximum weight 4 kg) will be mounted according to the illustration below.
When mounting we recommend to provide additionally four holes of 5-6 mm to the corresponding locations of the
hangers in the ceiling cut, which can be sealed from below with a dummy plug, that the plate in an emergency can be
11
removed from below.
4.4 Taking off the ceiling cover plate in an emergeny (only for trained staff)
If the lift can't be lowered in case of a power cut or a technical problem, you can get access to the unit by taking off the
ceiling cover plate. Take cake care that the plate does not drop in an uncontrolled way.
Now the problem can be analysed.
After disengaging the two carrying ropes the lift can be manually lowered by 20 cm.
Attention: Secure the lift with a prop .
Procedure: Loosen the two mounting plates to which the carrying ropes are attached (screws M4), move them upwards
10
and disengage them.
Now the lift can be lowered by 20 cm until it is secured by the carrying ropes again.
10
Now the screws of the projector holder and the cross bar can be loosened for taking out the projector.
In the same maintenance position the condensor motor could be exchanged, too. Contact our service team for further
instructions.

4.5 Adjusting the stop positions of the lift

The lift is delivered with two preprogrammed stop positions:
Stop position 1 Lift is in sleeping position
Stop position 2 Lift is in projection mode
To programme new positions use the optional programming unit Standard (7466000100).
28