Mounting On False Ceiling; Connection To Mains; Connection To Programming Unit - Kindermann Deckenlift compact2 80 Installationsanleitung

3.5 Mounting on false ceiling

If the ceiling lift is not mounted directly on a real ceiling the extension set with stabilizers is needed (7466000 019).
To guarantee a sturdy construction additional props may be necessary.
Attention: Before mounting the extension set the two stabilzers

4. Connection to mains

The motor of the ceiling lift is a reversal single phase condensor motor, similar to the ones used for shutters, with integrated
electronic stop switches, brake and transmission.
Connection the unit to the mains must only be done by an electrician. Never use damaged devices. Before mounting
the lift check the specifications on the lable with thoses of the local power supply. Do all mounting and maintenance
works with the power supply switched of.
The projector is connected to the mains via the provided wiring through the spiral cable guide
projector garage (see 3.1).

4.1 Connection to programming unit

Guide the 4-pin motor cable
Circuit diagram programming unit
Mains
PE N L
Switch for projetor
Ceiling lift
to the socket and connect the programming unit according to the following circuit diagram.
3a
Switch for
control of safety rope
blue
black
brown
yellow/green
Projector
Power socket
ceiling lift
a on the upper frame of the lift.
a
Mains
blue
black
brown
Programming unit
7466 000 100
yellow/green
to the mains socket of the
5a
25