Mounting The Projector; Prerequisites Of The Projector; Inserting The Projector - Kindermann Deckenlift compact2 80 Installationsanleitung

Wiring diagram programming unit
Lower the lift down to the pre-programmed bottom position and insert the signal and control cables to the projector into
the spiral cable guides /
5a
openings on the upper metal frame
Only use flexible cables. The required cable length within the unit varies between 2.5 m and 3.6 m (compact
Fix the spiral cable guide with the help of the clips to the concertina elements so that the wiring can't be damaged by the
up and down movements of the lift.
Caution: The switch is not suitable for permanent operation but only for moving the lift up and down.
Note: If the motor switches off before the lift has reached the end position, it is possible to overcome the locking by
shortly reversing the movement of the lift and then readjusting the end position.

4.2 Mounting the projector

4.2.1 Prerequisites of the projector

Three or four drill-holes (M3, M4, M5 or M6) on the bottom, distance between the drill-holes between 75 and 370 mm.
Max. weight: 20 kg. Mounting with only 3 carrying arms is possible.
Supplied with 4 sets of screws with washers M3, M4, M5, M6.
Required tools:
➡ 1 x screw driver
➡ 1 x Allen key No. 3
➡ 2 x spanners 10 mm

4.2.2 Inserting the projector

• The projector spider
9
taken off sidewards (illustration 1), after loosening the two screws
attached again likewise (illustration 2).
• With the help of the distance bolts you can even out different levels of the drill-holes in the projector bottom.
• Loosen the centre screw
• Put your projector upside down on a soft surface (illustration 3).
26
Splitter
(building)
green/yellow
blue
black
Mains
standard operation
Connection clamp
of programming unit
7466 000 100
1
Mains
Media controlled operation
. along the concertina elements. All the wiring to the lift resp. projector goes through the
5b
.
1
with four carrying arms and distance bolts are attached to the projector holder
of the projector spider with the 2 spanners 10 mm (illustration 2).
b
Safety switch
blue
gr/ye
green/yellow
blue
blue
brown
br
black
Cable between black
splitter and socket
at least 6-pin
(e. g. NYM 7x1.5 mm )
2
Motor
Socket
for switch/
socket
building
Socket / lift
Operation signal
2
Programming unit
Standard 7466 000 100
through the slots of the cross bar
a
120).
2
and can be
8
and can be
7