Adjusting The Projector; Mounting The Ceiling Cover Plate - Kindermann Deckenlift compact2 80 Installationsanleitung

• Find out the proper set of screws
four distance bolts. Use the suitable washers on both sides.
Attention: At least 3 distance bolts must be inserted.
•
Do not use any glue or grease. If the mounting is not done correctly, the projector can drop.
Danger of accidents or injuries.
If the distance bolts are longer than the drill-holes of your projector, use additional washers to avoid damages of
your unit.
• Fasten the centre screw
Hang the pre-mounted unit into the projector holder
screws through the slots of the cross bar.
Hints:
If necessary the projector holder
of the projector mount. If you change the position, make sure that the screws on the projector spider can be reached from
above.
After loosening the four screws the cross bar
fit onto the cross bar (illustration 4).
Ill. 1
a
7

4.2.3 Adjusting the projector

The projector hanging from the cross bar can be easily rotated resp. tilted by ca. ± 20°. In order to avoid a distortion of the
projected image, the projector should be exactly adjusted horizontally and vertically. When the mounting of the ceiling lift is
finished, the exact position of the projector to the screen should be secured by fastening the 10 mm screw on the projector
mount with a spanner.
8

4.3 Mounting the ceiling cover plate

The optional ceiling cover plate (7466 000152 resp. 7466000 153) is attached to the lift via the four adjustable extension
elements .
11
Choose the suitable elements according to the required length. After loosening the extension elements the height of the
cover plate can be adjusted.
Fasten the screws only slightly at first and do not tighten them before adjusting the stop positions of the lift (paragraph 4.5).
that fit into the drill-holes of your projector and fasten the carrying arms with the
10
of the carrying arms.
b
can be mounted in 6 different positions: left, centre, right, or set aside. Loosen the screws
8
can be taken off to the left or to the right or rotated if the projector does not
7
Ill. 2
8
b
9
on the cross bar . Secure the connection by fastening the two
8 7
Ill. 3 Ill. 4
27