Commissioning; A) Remove Car Body; B) Installing The Receiver Aerial Cable; C) Configuring The Speed Controller - Reely Supersonic Bedienungsanleitung

9.

Commissioning

a) Remove Car Body

Pull the safety clips out and take off the car body upwards.

b) Installing the Receiver Aerial Cable

Route the aerial cable through the enclosed aerial tube
and plug it into the corresponding holder between the
chassis and the servo/receiver; see arrow in the figure on
the right.
For a wide range, the aerial needs to protrude from the
vehicle as vertically as possible.
Ensure that the aerial cable is not damaged.
Never shorten the aerial cable! Never coil the
aerial cable! This greatly reduces the range!

c) Configuring the Speed Controller

The speed controller has two jumpers to configure the
driving function and the rechargeable battery type.
Jumper "Reverse" (A): This switches reverse driving off
("Disable") or on ("Enable").
Jumper "Battery" (B): Sets what sort of drive battery is
connected to the speed controller (LiPo or NiMH).
Important!
If you use a LiPo drive battery but set the re-
chargeable battery type to NiMH, the recharge-
able battery will be deep discharged and de-
stroyed.
Therefore, always set the proper rechargeable
battery type before operating the vehicle.
The setting "Lipo" causes the speed controller to reduce
the motor power to 50% when the battery voltage drops
below 6.5 V.
The speed controller switches off the motor below a bat-
tery voltage of 6.0 V. This way, the LiPo drive battery is
protected from harmful deep discharge.
For the setting "NiMH", the motor output will be reduced at a rechargeable battery voltage of less than 4.5 V; the motor
will be switched off if the battery voltage drops to under 4.0 V.
A
B
A
B
37