Connecting The Appliance; Switching On The Appliance; Selecting The Temperature - Bosch KSR Serie Gebrauchsanleitung

Connecting the
appliance
After installing the appliance, wait at least
½ hour before switching on the appliance.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be freely accessible.
Connect the appliance to
220-240 V/50 Hz alternating current via
a correctly installed earthed socket.
The socket must be fused with
a 10 A fuse or higher.
If the appliance is to be operated
in a non European country, check
on the rating plate whether the
indicated voltage and current type
correspond to the values of your
mains supply.
The rating plate is situated in the
bottom left hand side of the appliance.
The mains connection cable may
be replaced by an electrician only.
Warning!
!
Never connect the appliance
to electronic energy saver plugs or
to power inverters which convert the
direct current to 230 V alternating
current (e.g. solar equipment, power
supplies on ships).
Switching on the
appliance
Rotate temperature selector, Fig. 2/1,
from controller position 0".
The appliance starts refrigerating.
Interior light is switched on when the door
is open.

Selecting the temperature

We recommend storing perishable foods
at a temperature not warmer than +4 °C.
When the controller is at a medium
setting, the temperature drops to approx.
+4 °C in the coldest zone, Fig. 8.
Higher settings result in lower
temperatures in the refrigerator and
freezer compartments.
We recommend:
S for short term storage of food:
low controller setting
(energy saving mode, e.g. 1 2)
S for long term storage of food:
medium controller setting (e.g. 2 3)
S select a higher setting (e.g. 4 5) only
temporarily if: door opened frequently,
large amounts of food placed in the
refrigerator compartment.
en
19