Water Dispenser - Bosch KSW36PI30 Gebrauchsanleitung

Water dispenser

Cold water can be dispensed from
the appliance via the water dispenser.
When switching on, observe
the following
The water dispenser only works when
the appliance is connected to the water
mains.
When the appliance has been
connected, there are still air bubbles
in the lines.
Run off drinking water and pour away
until water can be dispensed without
bubbles. Pour away the first 10 glasses
(approx. 1.5 litre).
When the appliance has been installed
and switched on, temperature
differences may cause water to drip out
of the dispenser.
When the appliance has been switched
on, it may take several minutes until
water is dispensed.
Observing drinking water
quality
All materials used in the drinks
dispenser are odourless and tasteless.
If the water has an aftertaste, this may be
caused by:
Mineral and chlorine content
■
of the drinking water.
Material of the domestic water line
■
and connection line.
Freshness of the drinking water. If
■
water has not been dispensed for a
long time, the water may have a
"stale" taste. In this case fill approx.
10 glasses (approx. 1.5 litre) of water
and throw away.
We recommend that you regularly
dispense a little fresh water from the
water maker and that you do not switch
off the appliance. This will ensure that the
best water quality is retained.
Dispensing water
Fig. 5
Keep pressing the button until the
required quantity is in the glass.
Dispensing is limited to a time of
30 seconds. Then the dispenser button
must be pressed again if required.
Note
The water from the water dispenser is
cooled to a palatable temperature. If you
would like the water colder, place ice
cubes in the glass before dispensing
the water.
Note
When dispensing fairly large amounts of
water, the dispensed water may become
warmer.
Switching water dispenser on/
off
Fig. 5
Press water dispenser On/Off button 1.
The button is lit when the water
dispenser is switched on.
Switching button lock on/off
Fig. 5
The button lock prevents the appliance
from being operated unintentionally.
Press button lock button 2 for three
seconds. The button is lit when the
button lock is switched on.
en
31