Ice And Water Dispenser; Dispensing Water; Ice Maker; Dispensing Ice - Bosch KAD-Serie Montage- Und Gebrauchsanleitung

en

Ice and water dispenser

The following can be dispensed as required:
cooled water
Ø
cubed ice
Ø
crushed ice
Ø
You can choose the type of ice or water by touching
the (cubed ice), (crushed ice) or
button.
:
Warning
Do not use fragile receptacles for dispensing water
Ø
or ice – risk of injury from broken glass!
Keep fingers clear of the discharge opening. Risk of
Ø
injury from crusher blades!
Note:
The ice and water dispenser will not function when the
freezer door is open or child lock is active.

Dispensing water

The water from the dispenser is cooled to a palatable
temperature. If you would like the water colder, place
ice cubes in the glass before dispensing the water.
1.
Press button to activate dispenser mode "water".
1.
Display will illuminate, when "water" mode is
active.
Press the glass against the dispenser lever.
2.
The water stops running when the glass is removed
from the lever.
Do not immediately remove your glass from under
the dispenser after dispensing water. Wait for 2 or
3 seconds to prevent spills.
Note:
If no water is dispensed or it is dispensed slowly,
the water filter may be clogged and may need to be
replaced
(~ chapter "Replacing the water filter").
40
(water)
2.

Ice maker

When the freezer compartment has reached its freezing
temperature, water flows into the ice maker and freezes
into ice cubes. When the ice cubes are ready, they are
automatically discharged into the ice bucket.
Turning off the ice maker
The ice maker can be turned off to save water and
energy, if no ice is needed.
Press the "ice on/off" button to turn on or off the ice
maker. Display (ice off) is illuminated, when the
ice maker is turned off.
Note:
"ice on/off" only concerns the ice maker, not
the dispenser.
Emptying the ice bucket
If you do not dispense ice for a long period, ice may
clump in the ice bucket. If this occurs, please remove
and empty the bucket
(~ chapter "Cleaning the appliance").

Dispensing ice

1.
Press button or
1.
"cubed ice" or "crushed ice".
Corresponding display
selected mode is active.
Press a suitable receptacle against the dispenser
2.
lever.
Remove the receptacle from the dispenser lever
when it is approx. half full. Ice in the discharge
may cause the receptacle to overflow or block the
discharge.
Do not immediately remove your glass from under
the dispenser after dispensing ice. Wait for 2 or
3 seconds to prevent spills.
Notes
After switching over from dispensing cubed ice to
Ø
crushed ice, the dispenser may still contain whole
ice cubes or pieces of ice cube. These will be
dispensed with the first portions of crushed ice.
After switching over from dispensing crushed ice
Ø
to cubed ice, a small amount of crushed ice may
be dispensed with the first portions of cubed ice.
Do not dispense ice continualy more than one
Ø
minute during normal use to avoid excessive
temperature on the ice crusher motor.
2.
to activate dispenser mode
or will illuminate, when