Yamaha TT-R90E Handbuch Seite 54

STARTING AND OPERATION
CAUTION:
Prior to operating the machine, perform
steps listed in pre-operation check list.
WARNING
Never start your engine or let it run for any
length of time in a closed area. The exhaust
fumes are poisonous and can cause loss of
consciousness and death within a short
time. Always operate your machine in an
area with adequate ventilation.
STARTING A COLD ENGINE
TT-R90
WARNING
Before starting the engine, be sure to shift
the transmission into neutral.
1. Turn the fuel cock to "ON".
2. Operate the starter (choke) and com-
pletely close the throttle grip.
3. Slide the "ENGINE STOP" switch to the
" ".
4. Kick the kick starter with full strength to
start the engine.
5. After the engine starts, warm up for one
or two minutes. Make sure the stater
(choke) is returned to the original position
before riding.
TT-R90E
WARNING
Before starting the engine, be sure to shift
the transmission into neutral.
NOTE:
This model is equipped with an ignition cir-
G
cuit cut-off system. In case of electric start-
ing, the engine can be started only when the
transmission is in neutral.
If the engine fails to start by pushing the start
G
switch, release the switch, wait a few sec-
onds, and then try again. Each starting
attempt should be as short as possible to
preserve the battery. Do not crank the
engine more than 10 seconds on any one
attempt. If the engine does not start with the
starter motor, try using the kickstarter.
STARTING AND OPERATION
1. Turn the fuel cock to "ON".
2. Turn the main switch to "ON".
3. Shift the transmission into neutral.
4. Operate the starter (choke) and com-
5. Start the engine by pushing the start
6. After the engine starts, warm up for one
STARTING A WARM ENGINE
To start a warm engine, refer to the "Starting a
cold engine" section. The starter (choke)
should not be used. The throttle should be
opened slightly.
CAUTION:
See "Engine break-in Section" prior to
operating engine for the first time.
WARMING UP
To get maximum engine life, always "warm-up"
the engine before starting off. Never accelerate
hard with a cold engine! To see whether or not
the engine is warm, see if it responds to throt-
tle normally with the stater (choke) turned off.
WARNING
Before starting off, be sure to turn up or
remove the side stand.
Failure to retract the side stand completely
can result in a serious accident when you
try to turn a corner.
ENGINE BREAK-IN
Brake-in is important to better fit the moving
and sliding parts as well as the installed parts.
It is also important to accustom the rider to the
machine better.
Avoid full-throttle run on a new machine for the
first 5 hours.
After the trial run, check for loose parts, oil
leakage and other problems.
Make full inspection and adjustment especially
of slack cables and drive chain and loose
spokes.
CAUTION:
After the break-in period, check every fit-
ting and fastener for looseness.
If any loose is found, retighten it securely.
1 - 13
pletely close the throttle grip.
switch or by kicking the kickstarter.
or two minutes. Make sure the stater
(choke) is returned to the original position
before riding.
GEN
INFO