Recording (Audio And/Or Video); About The Memory Functions; Initialization Of The Microprocessor - Denon AVR-2807 Bedienungsanleitung

ENGLISH
Advanced Operation
<NIGHT>
<FUNCTION> <PURE DIRECT>
<POWER>
<ZONE2/REC SELECT>
About the button names in this explanation
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit

Recording (audio and/or video)

1 < ZONE2/REC SELECT >
Press until "RECOUT"
appears on the display.
ZONE2 RECOUT
2 < FUNCTION >
Use to select the source to be
recorded (audio and/or video).
• The " " indicator lights.
3
Record (the audio or video signals).
For operations, see the operating instructions of the device
from which you are recording (audio or video signals).
• To cancel, press < ZONE2/REC SELECT > and set the function to
"ZONE2".
NOTE:
• When the REC OUT mode is selected, [ZONE2] and
[FUNCTION] (ZONE2) cannot be operated.
• Digital signals are not output from the analog REC OUT,
OPTICAL 3 OUT and OPTICAL 4 OUT terminals.
42
ENGLISH

About the memory functions

2 Last function memory
The various settings set when the AVR-2807's power is switched
to standby are stored in the memory. When the power is turned
back on, the settings made when the power was switched to
standby are recalled.
2 Backup memory
The various settings are stored in the memory for about 1 week,
even when the power is turned off or the power cord is
unplugged.

Initialization of the microprocessor

Use the procedure described below to reset the microprocessor
if the display is abnormal or if the buttons on the main unit or the
remote control unit do not operate.
< POWER >
1
Switch off the unit using
2 < PURE DIRECT >
Hold the following
< POWER >
and press .
3 Check that the entire display is blinking with an
interval of about 1 second, and release your
fingers from the 2 buttons.
• The microprocessor will be initialized.
• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the settings are reset
to the default values.
Advanced Operation
.
< NIGHT >
and ,