Pre-Tare-Function - KERN PCB 200-2 Betriebsanleitung

Delete tare
TA R E
PRE-TARE-
Function
M O D E
C A L
Delete PRE-TARE
value
M O D E
C A L
PCB-BA-e-1718
 Weigh the material, the net weight will be indicated.
The taring process can be repeated any number of times,
e.g. when adding several components for a mixture
(adding). The limit is reached when the whole weighing
range is exhausted.
The weight of the weighing container will be displayed as a
minus number after removing the weighing container.
The tare weight is saved until it is deleted.
 Unload the balance and press the TARE button, the zero
display appears.
Using this function the weight of a tare vessel is stored. Even
after turning off/on the weighing balance will continue working
with the saved tare value.
 In weighing mode put tare vessel on the weighing plate
 Press repeatedly the MODE key until „PtArE" flashing
appears.
 Use SET key to store the current weight on the weighing
plate as a PRE-TARE value.
 Remove all loads from the balance and press repeatedly
the MODE key until „PtArE" flashing appears.
 Use the SET key to confirm. The PRE-TARE value is
deleted, the zero display appears.
19