Printout - KERN PCB 200-2 Betriebsanleitung

printout

Using this function data are selected which are to be sent via the
RS232C (not valid for data transfer mode BAPr ).
 In weighing mode keep the PRINT key pressed until [Unit]
 Press the MODE key several times until „LAPr" is displayed.
 Acknowledge using SET key, the current setting is displayed.
 Select the desired output parameter by pressing the MODE key
 After actuating the SET button, the current state is displayed ( on
 Use MODE and PRINT key to change the status
 Use the SET key to confirm selection. The balance returns to
By that way the user can configurate his own data block, which then
is sent to a printer or to a PC.
36
appears.
Edition of the headlines
Hdr
GrS Edition of the total weight
Edition of the net weight
Net
tAr Edition of the tare weight
N7E Edition of the stored weight
Edition of quantity
PCS
AUJ Edition of the unit weight
Edition of the reference quantity
Rqt
FFd Edition of a page feeding at start printer output
FFE Edition of a page feeding at end printer output
/ off ).
„on  off".
weighing mode.
PCB-BA-e-1718