Setting The Factory Preset - Yamaha YSP-900 Bedienungsanleitung

4
Press / to switch between DEMO: ON
and DEMO: OFF.
DEMO: ON
DEMO: OFF
• Select DEMO: ON to activate the demo mode.
• Select DEMO: OFF to deactivate the demo mode.
5
Press STANDBY/ON on the front panel to set
this unit to the standby mode.
STANDBY/ON
The new setting will be activated when you turn on
the power of this unit next time.
Press ENTER to test the sound beam.
The sound beam being output shuttles between left
and right. Press ENTER again to stop shuttling.
ENTER
VOL
VOL
ADJUSTING SYSTEM PARAMETERS

Setting the FACTORY PRESET

You can reset all of the parameters of this unit to the
factory presets. This procedure completely resets ALL the
parameters in SET MENU.
Note
After performing the following procedure you must run the
AUTO SETUP again to match your surround sound environment.
1
Repeat steps 1 to 3 in "Using the system
parameters" on page 72.
2
Set the operation mode selector to YSP to
switch to the operation mode of this unit.
TV/AV
YSP
3
Press / on the remote control so that
FACTORY PRESET is shown in the front
panel display.
FACTORY PRESET
4
Press ENTER.
ENTER
ENTER
VOL
75
En