Yamaha YSP-900 Bedienungsanleitung Seite 34

AUTO SETUP (IntelliBeam)
8
Check that the following screen is displayed
on your TV.
The results of the AUTO SETUP procedure are
displayed on your TV.
Example 1
SHOW RESULT
MEASUREMENT COMPLETE
BEAM MODE :5 BEAM
SUBWOOFER :NOT APPLICABLE
[ENTER]:Save set-up.
[RETURN]:Do not save set-up.
Example 2
SHOW RESULT
MEASUREMENT COMPLETE
ENVIRONMENT CHECK[FAILED]
BEAM MODE
SUBWOOFER :YES
[ENTER]:Save set-up.
[RETURN]:Do not save set-up.
y
• If ''ENVIRONMENT CHECK [FAILED]'' is
displayed, we recommend running the AUTO SETUP
procedure again. For details, see step 9.
• If ''SUBWOOFER : NOT APPLICABLE'' is
displayed even though a subwoofer is connected to this
unit, increase the volume level of the subwoofer and
run the AUTO SETUP procedure again.
• Depending on the environment of your listening room,
the beam angle of front left and right, and surround left
and right may be set to the same value even if 5BEAM
is displayed as a result.
9
Press ENTER to confirm the results or press
RETURN to cancel the results.
The following screen is displayed temporarily for 2
seconds and then disappears from your TV.
ENTER
If ''ENVIRONMENT CHECK [FAILED]'' is displayed
in step 8, the following screen is displayed after pressing
ENTER. In this case, see ERROR E-1 in "Error messages
for AUTO SETUP" on page 33. Press ENTER to exit the
AUTO SETUP and then run the procedure again from
step 3.
AUTO SETUP COMPLETE
Your YSP unit may not be set
up correctly.
We recommend you try again.
Please press [ENTER] key to
exit.
32
En
:5 BEAM
AUTO SETUP COMPLETE
Please remove the MIC from
the YSP and the listening
position.
10
Disconnect the optimizer microphone from
the OPTIMIZER MIC jack on the front panel.
OPTIMIZER MIC