Assembly And Installation; Scope Of Delivery; Mounting Location; Required Separation Distances - Vaillant VER 75/4 Betriebsanleitung

The Vaillant VER electrical room heaters are used as
flat, wall-mounted units for warming and heating rooms
used for short periods, such as bathrooms, kitchens or
hobby rooms. They allow the temperature to be control-
led precisely by means of an adjustable electronic ther-
mostat with frost protection.
The housing of the special heating element is provided
with air slots underneath and at the front.
The air is heated by free convection without a fan. The
cold air to be heated enters the unit from underneath,
flows across the special heating element and exits as
warm air via the air outlet grill. The convector is fitted
with an electronic thermostat on the upper right side of
the unit. The thermostat allows the temperature to be
set variably by means of a dial.
4

Assembly and installation

4.1

Scope of delivery

4
3
2
Fig. 4.1 Scope of delivery
> Check the delivery for completeness and lack of dam-
age (¬ fig. 4.1 and ¬ table. 4.1).
Pos. Number Name
1 1 VER electrical room heater
2 1 Appliance holder
3 1 Bag with fixing material
4 1 Operating and Installation Manual
Table 4.1 Scope of delivery
Installation manual VER 0020064153_01
Für den Fachhandwerker
Installationsanleitung
eloBLOCK
Elektro-Wandheizgerät
HR
1
Description of the appliance 3
Assembly and installation 4
4.2

Mounting location

e
Danger!
Danger of fatal electric shock!
> Only mount the unit in areas where it can-
not be touched by a person from the bath
or shower.
a
Danger!
Danger of fire!
The temperature of the housing can exceed
60°C.
> Do not install the unit immediately under-
neath a wall socket.
> Install the unit outside of the minimum sep-
aration distances from floors, walls, cur-
tains, furniture etc, as shown in fig 4.2.
4.3

Required separation distances

Fig. 4.2 Separation distances at the installation site
The Vaillant VER electrical room heaters are mounted
vertically on the wall.
The minimum separation distances from floors, walls,
curtains, furniture etc. must be observed according to
figure 4.2. After installation, the mains plug must be
accessible at the side of the unit.
INT 5
EN