Disposal; Disposal Of The Appliance - Silvercrest SHBS 600 A1 Bedienungsanleitung

NOTE
► In order to reduce friction, occasionally apply a couple of drops of blade
oil (accessory) between the blades, and then distribute it evenly. You can
also use any non-corrosive oil (e.g. sewing machine oil). Wipe off any
access oil with a soft cloth.

Disposal

Disposal of the appliance

Under no circumstances should you dispose of the appliance in
normal household waste. This product is subject to the provisions
of European Directive 2012/19/EU (Waste Electrical and Electronic
Equipment).
Dispose of the appliance via an approved waste disposal company or your
municipal waste disposal facility. Please observe applicable regulations. Please
contact your waste disposal facility if you are in any doubt.
NOTE
► Before disposing of the appliance it is essential to fi rst remove the battery.
WARNING
► Removal of the battery requires a certain amount of manual dexterity;
otherwise there is a risk of injury! If you have no experience in using tools,
you should entrust the task to someone who is competent to do the job
properly.
► Ensure that the battery does not get damaged during removal. Risk of fi re!
► The removed battery may not be reused.
► Never short-circuit the battery. The contacts on the removed battery should
not be connected by an metallic objects. The battery can overheat and
explode.
► WARNING! Only remove the battery for disposal of the appliance.
Removal will destroy the appliance. Never operate an appliance that has
been dismantled.
♦ Disconnect the appliance from the power supply.
♦ Switch on the appliance and let it run until the battery is fully discharged.
♦ Remove the cutting unit
♦ There are three screws on the rear of the appliance. Two of the screws are in the
mounting opening for the cutting unit.
♦ Loosen both the screws with a Phillips screwdriver.
SHBS 600 A1
from the appliance (see chapter Cleaning and care)
GB
IE
11